- introduction of equipment
- SURGE TEST / Withstanding Voltage Tester / LASER ALIGNMENT
Waveform Comparison Test
Check insulation between turn turns
You can check the insulation between turns by applying the impulse voltage and comparing the waveforms of the windings.
Withstanding Voltage Tester
Dielectric Strength Test
AC voltage (2E + 1000V) can be applied to check insulation between motor and ground.
Capacity 50KVA (14000V grade available for nuclear power)
Precision Alignment Using Laser
Can be set to 0.001mm
Coupling interval can be measured up to 10m
Can store 100,000 data
(Our standard OD: 5 / 100mm, FACE: 5 / 100mm) There is no error due to jig deflection of analogue analog